Job Information
Fox Valley Metal Tech Welding Inspector I in Green Bay, Wisconsin
Read and interpret basic drawings, weld procedure specifications (WPS), and welding symbols
Able to identify weld discontinuities
Basic understanding of weld acceptance criteria
Basic weld inspection tool usage: fillet gauge, V-WAC gauge, combination square, protractor, caliper, tape measure, flashlight, mirror, magnifying glass, temperature crayon
Ability to answer welding-related questions or know where to direct questions
Fully inspect weldments and sub-weldments
Document results of inspections, including VT reports and weld maps
Comprehend the introduction to First Article Inspection (FAIs)
Communicate welding nonconformances to Welding Supervisor, Welding Trainer, Welder Development Coordinator, Lead Weld Inspector
Maintain material certifications and inspection documentation
Label nonconforming parts
Use calibrated measuring equipment where applicable
Follow all safety procedures
Ability to work in a fast-paced environment is required
Good verbal and written communication skills is required
Education:
- GED/High School Diploma/Technical Degree
Experience:
1-3 Years welding experience and/or
1-3 Years welding inspection experience
Specialized Experience:
ASNT VT Level II – preferred
Acquire certification within 60 days of hire
Physical Demands: The physical demands described below are representatives of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
While performing the duties of this job, the employee is required to:
Frequently: sit, grasp/hold, fine manipulation of both hands
Occasionally: reach at shoulder, lift/carry, and walk
Seldom: stand, reach below shoulder, reach above shoulder
Percent of job performed per Hours Worked:
0% - 15% Seldom
16% - 33% Occasionally
34% - 65% Moderate
66% - up Frequently